aeno.com/documents 9
Operation of the device
Install the replaceable toothbrush head (2) onto the handle (1) as shown in
figure b. Apply some dentifrice to the brush bristles. Press the power button
(10). One of the indicators showing the operating mode of the device will light
up. The device will operate in the specified mode. To turn off the device, press
the button (10) again.
The device has three modes of vibration intensity (8): low, medium, high. To
change the mode, switch the device off and on again with the button (10). Then
quickly slide your finger down or up on the touchpad (9) to adjust the vibration
intensity up or down. 5 seconds after turning on the device, the touch panel
will be locked.
A vibration signal is triggered every 30 seconds, reminding you of the
opportunity to switch the operating mode. To change the mode, switch the
device off and on again with the button (10). Then quickly press the button (10)
several times in succession, selecting the desired mode. Each time you press,
the mode changes to the next. The last used mode remains in the device's
memory. This mode will be automatically selected the next time the device is
turned on.
Guide the brush head at a 40° angle to the surface of the teeth, as shown in
Figure c. In this position, the toothbrush head works most efficiently.
Device operating modes table
(figure a)
Daily standard cleaning mode
Teeth polishing and whitening mode.
Recommended for smokers and frequent
coffee drinkers
Intensive gum massage. Recommended
for healthy gums after standard cleaning
To Next Page
Loading...