AENO EK1S - Page 9

aeno.com/documents 9
If the connection fails, make sure the device is connected to a power source
and turned on and check the Wi-Fi router settings at aeno.com/router-help.
Remove the kettle from the stand, put it back on and then repeat the
connection process.
Note: The device can also be controlled via voice assistants. Detailed
information is available in the Installation and Operation manual at
aeno.com/documents.
Maintenance and descaling
WARNING! Before cleaning unplug the kettle by removing the power cord plug
from the socket and allow it to cool down.
Wipe the outside of the kettle with a soft cloth soaked in warm water or a weak
soap solution. Then wipe with a soft cloth soaked in clean water and wipe dry.
Do not use harsh detergents, abrasive pastes, polishes or detergents
containing acids or solvents.
Frequency of descaling: once a month (hard and very hard water) or once every
2–3 months (water of medium hardness or soft), when using the kettle 3–
5 times a day.
Limescale remedies and cleaning methods
Table
vinegar
Citric acid
Descaler
Pour 0.5
l of vinegar (6
% or
9 %) into the kettle, leave
for 1 hour without boiling.
Pour out the contents,
wash the kettle by
drawing and draining the
water 5–6 times
Boil 0.5
l of water. Add 25
g
of citric acid and leave for
15 min. Pour out the
contents, wash the kettle
by drawing and draining
the water 5–6 times
Follow the
manufacturer's
instructions on the
product package
Troubleshooting
 The device does not turn on. Possible causes: there is no voltage from the
power socket; the kettle is not properly placed on the stand. Solution: check