AENO GS1 - Page 9

aeno.com/documents 9
Number of
indicators
Status
Definition
2
Indicators are
lit steadily
Medium operating mode is selected
3
Indicators a
re
flashing
Self
-
cleaning is necessary
3
Indicators are
lit steadily
Maximum operating mode is selected
Button Functions (see fig. A)
№
Action
Definition
8
Press once
Turn the device on/off
9
Press once
Switch operating modes
10
Press once
Turning the
steam supply on/off
Preparing the Device for Operation
1. Carefully open the packaging and remove the device and accessories.
2. Remove the water tank (see fig. C).
3. Clean the device (see “Cleaning and Maintenance”)
4. Fill the tank with water. To make the process easier, use the supplied
measuring cup (12).
WARNING! Use distilled water only.
5. Install the water tank in the device. You should hear a distinctive click when
the tank is properly installed.
6. Insert the plug of the power cord into an outlet. The power indicator (6) will
start flashing.
7. Press the power button (8). The power indicator will light up steadily and the
operating mode indicator (7) will start flashing.
8. Wait about 35 s until the water is heated. When the heating is complete, the
operating mode indicator will light up steadily.
9. Perform a test run of the device (see “Test Run”).