14 aeno.com/documents
TIME" +
one of the
program
indicators
start
control
seconds
Cleaning
Troubleshooting
The smell of burning plastic or rubber. Possible causes: the device motor is
inside the housing under strong rubber materials to reduce noise and
vibration. The first few starts the parts of the device will be hot and emit an
unpleasant odor. Later on, the smell will disappear. Solution: It is recommended
to install the blender in a well-ventilated room.
The products are not well chopped. Possible causes: low mains voltage; too
much or too little food in the bowl; not enough water in the bowl. Solution: plug
the device into an outlet with a supply voltage of at least 220V, use a voltage
regulator; remove excess food from the bowl or add water to it.
The liquid pours over the edge of the blender bowl. Possible causes: too much
liquid. Solution: make sure that the amount of liquid does not exceed the
maximum level specified in the instructions.
To Next Page
Loading...
