What to do if my AENO Blender heats up and the blade doesn't rotate?
If your AENO Blender heats up and the blade does not rotate, it could be due to an electrical circuit short circuit. In this case, you should contact the service centre.
What to do if my AENO TB2 shuts down during operation?
If the AENO Blender shuts down during operation, it may be due to the overheat or overload fuse tripped. Follow the instructions in paragraph 2.4 "Overload and overheat protection".
What does error E3 mean on my AENO Blender?
Error E3 on the AENO Blender indicates that there is no liquid or food in the jug, and the temperature sensors have shut off the device due to overheating. To resolve this, add liquid or food to the jug.
What to do if the liquid overflows over the edge of my AENO TB2 jug?
If the liquid overflows over the edge of the AENO Blender jug, it is likely because there is too much liquid in the jug. Ensure that the amount of liquid does not exceed the maximum level specified in Table 4, "Limitations on the volume of ingredients in the jug".
Why is my AENO TB2 Blender not chopping food well?
If your AENO Blender is not chopping food well, it could be due to several reasons: low mains voltage (plug the device into an outlet with a supply voltage of at least 220 V, use a voltage regulator), too much or too little food in the jug (remove unnecessary food from the jug or add it), or too little water in the jug (fill the jug with water).
What do errors E1 and E2 mean on my AENO Blender?
Errors E1 and E2 on your AENO Blender indicate that the large lid and/or blender cup are installed incorrectly or skewed. Remove the large lid and/or blender jug and reinstall them again.
Why does my AENO TB2 smell like burning plastic?
If you notice a burning plastic or rubber smell coming from your AENO Blender, it's because the device's motor is located inside the housing under rugged, wear- resistant rubber materials to reduce noise and vibration. Install the device in a well- ventilated area. The first few starts, the parts of the device will be hot and emit an unpleasant odor. The odor will disappear at a later time.
To Next Page
General