AENO TB2 - Figure 10 - Installing the Bowl on the Housing

Installation and Operation Manual for
the AENO TB2 electric blender
© ASBISc Enterprises PLC. All rights reserved Document version: 1.0.1, aeno.com
Page 29 of 44
NOTE
If you open the large lid while the device is running, the blender will stop
immediately. If you need to add small amounts of food or spices while the
blender is running, you can open the small lid to do so. Use the measuring cup
included in the package for accurate dosage of spices and other products.
Place the jug on the blender housing so that the jug connector (a) fits into the groove
in the blender housing (b).
Figure 10 – Installing the bowl on the housing
If the jug does not fit on the housing, remove it and twist the motor shaft connector (c)
in the blender housing by hand half a turn in either direction.