AENO TB2 - Maintenance; Cleaning the Device Housing; Figure 14 - Cleaning the Device Housing

Installation and Operation Manual for
the AENO TB2 electric blender
© ASBISc Enterprises PLC. All rights reserved Document version: 1.0.1, aeno.com
Page 33 of 44
3 Maintenance
WARNING!
Make sure that the device is turned off and disconnected from the power supply
before starting maintenance.
To maintain optimum condition and stable operation of the device, it is recommended
to perform the following actions:
• clean the device housing if there is any dirt;
• cleaning the jug after each use of the device.
WARNING!
Do not use harsh chemicals, abrasive pastes, polishes or detergents that contain
acids or solvents, or metal sponges, which can damage the coating.
3.1 Cleaning the device housing
Use a damp cloth to wipe off dirt and dust on the device housing. For heavy soiling,
apply a neutral detergent to the cloth and clean the soiling (see figure 14). Then wipe
the body of the device with a damp cloth and wipe it dry.
Figure 14 – Cleaning the device housing