1.5.2 Power monitoring mode
To turn the device on in power control mode, place the jug on the motor device and
plug the device into the power outlet.
The device will go into power monitoring mode. The control panel display will show "-
- --".
The ON/OFF button will start flashing.
1.5.3 Standby mode
To turn the device on in standby mode, place the jug on the base of the blender and
do the following
• Plug the device into an outlet.
• Press the "ON/OFF" button.
The device will go into standby mode. The control panel display will show "00:00". All
indicators will light up blue.
If no buttons are pressed after this, after one (1) minute the blender will go into power
control mode.
1.5.4 Operating mode of the device
To activate the device in the operating mode, place the jug with the ingredients on the
blender body and perform the following actions:
• Plug the device into an outlet.
• Press the "ON/OFF" button.
• Select the desired device program by pressing the "Function" button. If no
buttons are pressed after that, after 30 (thirty) seconds the blender will go into
standby mode.
• Press the "ON/OFF" button.
The device will start executing the selected program. The indicator of the selected
program will light up blue. The display of the control panel will show the temperature
of the ingredients in the jug.
After boiling, the display will show the operating time of the selected cooking program.
For programs without heating the running time is displayed immediately after the
mixing starts.
To Next Page
Loading...