Installation and Operation Manual
for AENO TB2 electric blender
Document version: 1.0.1, aeno.com © ASBISc Enterprises PLC. All rights reserved
Page 44 of 44
The electrical safety class that implies protection against electric
shock is provided by the use of double or reinforced insulation.
No enclosure grounding is required. The plug does not have a
grounding contact.
AISI 304 (The American Iron and Steel Institute) austenitic steel
with low carbon. AISI 304 stainless steel is acid-resistant and can
withstand short-term elevated temperatures of up to 900
degrees Celsius.
Shock-resistant technical plastic, widely used in the
manufacture of household products.
Polypropylene, food grade plastic It has high strength and heat
resistance, safe to use with any food.
Silicate glass, where the alkaline components in the raw
material are replaced by boron oxide. It differs from conventional
glass by its higher thermal resistance and increased resistance
to mechanical damage.
Waste Electrical and Electronic Equipment means used
electrical or electronic equipment, including all components,
subassemblies, consumables that are part of the equipment at
the time it is taken out of service (including batteries/batteries
(if any), components containing mercury, etc.)
To Previous Page
Loading...
