1.5.5 Self-cleaning mode
In self-cleaning mode, the device removes food debris from the walls of the jug and the
knife mechanism of the device.
To activate the self-cleaning mode, after removing the finished product from the
blender jug, pour 500 ml of warm water with a few drops of neutral* dishwashing
detergent into it. Close both covers and press the "CLEANING" button.
The blender blade mechanism will rotate as long as you hold down the "CLEANING"
button. After you finish cleaning, rinse the inside of the jug with clean warm water and
wipe with a dry cloth. Take care not to be injured by the blender's sharp blades.
1.5.6 Delayed start mode
To activate the device in the delayed start mode, place the jug with the ingredients on
the blender body and perform the following actions:
• Plug the device into an outlet.
• Press the "ON/OFF" button.
• Press the "Preset Time" button one or more times. Each press of this button
increases the time until the blender starts by 30 minutes. The maximum
allowable delayed start time is 24 hours.
*According to publicly available information, dishwashing detergents with a pH value of 5 to 8 are neutral.
To Next Page
Loading...
