AENO TB2 - Figure 2 - Elements of the Device

Installation and Operation Manual for
the AENO TB2 electric blender
© ASBISc Enterprises PLC. All rights reserved Document version: 1.0.1, aeno.com
Page 13 of 44
Figure 2 – Elements of the device
Elements of the device (see figure 2):
1
– small lid, used to add ingredients to the blender jug during operation
2
– large lid with an opening for a small lid
3
– large lid retainer
4
– blender jug
5
– blender jug handle
6
– six-blade knife mechanism
7
– blender jug base
8
– compensators to reduce jug vibration during operation
9
– motor shaft connector
10
– guide groove for jug installation
11
– engine block
12
– touch screen control panel
13
– blender base with holes for air intake and exhaust