2 Installation and operation
2.1 Unpacking and preparing for work
Figure 5 – Installation and preparation for operation
1. Carefully open the package and remove the device and accessories.
2. Thoroughly wash and dry the elements of the device that will come into contact
with food (jug, large and small lids, measuring cup, pusher), following the rules
of cleaning in section 3 "Maintenance".
3. Place the device in the selected location on a flat, stable, horizontal surface (see
picture above) at least 15 cm away from other objects.
4. Plug the power cord into a power outlet.
NOTE
Before connecting the device to the mains make sure that the rated voltage
indicated in the technical documentation corresponds to the electrical voltage
of the outlet.
WARNING!
When connecting, operating and storing the AENO electric blender, follow the
rules for safe use of the device (see "Limitations and Warnings" section).
To Next Page
Loading...