AENO TB2 - Page 43

To Next Page

To Previous Page

Installation and Operation Manual for

the AENO TB2 electric blender

Page 43 of 44

№

Problem

Possible causes

Solution

Blender heats up,

blade does not

rotate

Electrical circuit short

circuit

Contact the service centre

The device shut

down during

operation

Overheat or overload fuse

tripped

Follow the instructions in

paragraph 2.4 "Overload and

overheat protection"

WARNING!

If none of the possible solutions solves the problem, contact your supplier or

service centre. Please do not disassemble or attempt to repair the device on your

own.

Main Page

Introduction3
This Manual Contains a Detailed Description of the AENO TB2 Blender as Well as Instructions for Its Preparation, Operation and Maintenance3
Copyrights3
Responsibility and Technical Support4
Standards Compliance5
Limitations and Warnings6
Table of Contents9
Contents9
General Description and Specifications11
Purpose of the Device11
Figure 1 - Appearance of the Device11
Figure 2 - Elements of the Device13
Specifications14
Package Contents16
Figure 3 - Package16
Packaging and Labelling17
Device Control Panel18
Control Panel Buttons18
Figure 4 - Device Control Panel18
Power Monitoring Mode20
Standby Mode20
Operating Mode of the Device20
Self-Cleaning Mode21
Delayed Start Mode21
Installation and Operation23
Unpacking and Preparing for Work23
Figure 5 - Installation and Preparation for Operation23
Description of Program Operation24
Operating the Device25
Figure 6 - Ingredients Preparation26
Figure 7 - Blender Bowl Label27
Figure 8 - Small Lid Closing Diagram28
Figure 9 - Large Lid Closing Diagram28
Figure 10 - Installing the Bowl on the Housing29
Figure 11 - Motor Shaft Connector30
Figure 12 - Program Indicators30
Figure 13 - Extracting the Finished Product31
Overload and Overheat Protection32
Maintenance33
Cleaning the Device Housing33
Figure 14 - Cleaning the Device Housing33
Cleaning the Jug and Accessories34
Figure 15 - Cleaning the Bowl34
Figure 16 - Electrical Contacts in the Bowl Handle35
Figure 17 - Cleaning the Device Covers36
Figure 18 - Prohibition of Contact with Water36
Warranty37
AENO Service Centers37
Warranty Service Procedure38
Limitation of Liability38
Storage, Transportation and Disposal40
Other Information41
Troubleshooting42
Glossary44

AENO TB2 - Page 43

Table of Contents

Other manuals for AENO TB2

Related product manuals