How to use ESC
How to use linear servo
TELEM Function Introduction
Connect the positive pole of the brushed motor to“M+” and the negative pole to “M-”to replace the
throttle channel, as above picture.
The integrated brushed ESC has the lock function of preventing accidental touch. After the receiver is
powered on, the throttle channel remains at the lowest position for more than 2 seconds, then this function
can be canceled and the brushed ESC can be used normally.
After combining the transmitter, then can control 2pcs linear servos.(Usually, used for the horizontal tail and
vertical tail.)
If you need to adjust the channel sequence or reverse, you can use transmitter’s channel mapping function
to revise it.
Firstly , you need a remote control with TELEM to use this TELEM function.
This function could realize real-time monitoring to battery voltage, receiver voltage, receiver signal strength
and receiver operating temperature, allowing users to master the working status of receiver and battery in
real time to avoid unexpected situations in flight.
AEORC RX24x Series Mini Micro Receiver (2CH with Linear Servo)
Instruction Manual
To Next Page
Loading...
Need help?
General
