OPERATING INSTRUCTIONS
START OPERATION
1. Place the product in an upright position on a flat, stable, and
heat-resistant surface. Make sure there is nothing
flammable
or
heatsensitive
within 39 in.
Operating
the
product
in
any
other
position could cause a hazard.
2.
Insert the plug into a suitable wall socket. The dehumidifier is
suitable for operating on an electricity
supply
having the same
voltage as that shown on its rating label.
3.
Make sure the water tank
is
correctly located. After switching on
the machine for the first time,
if
the "Bucket Full" light illuminates,
pull
out the water tank and check that the "float" lever is able to
move freely, then return the water tank to the correct position (Fig.
1)
.
WATER FULL INDICATOR LIGHT (RED)
Float lever
~
When the water tank is full and/or incorrectly positioned inside the cabinet, the water full red light
turns on and remains on until such time that the tank is emptied and/or correctly re-positioned.
This condition will result
in
the immediate shut down
of
the dehumidifying system (both compressor
and fan motor operations are terminated). This
is
a safety feature. When the water tank is emptied
and/or
correctly re-positioned, the dehumidifier will resume operation automatically.
NOTE: It may take several minutes before operating conditions resume.
BUCKET FULL LIGHT
• When the water tank is full the machine will stop and the" Bucket
Full" light will illuminate.
•
The water tank should be carefully removed from the machine by
sliding it outward from the front
of
the unit and it should be emptied.
When the empty tank is replaced properly
in
the machine, the unit
will start up and run normally (Fig.
2)
.
NOTE: Please use both hands to carefully empty the water tank.
FACTORY DEFAULT SETTING
Humidity Setting: 30% Fan Speed: Low
NOTE:
In
the event
of
a power failure, the unit will default to the last program setting that was used
when power is restored (does not
include TIMER setting).
WATER TANK OPERATION
Proper installation
of
the water tank is crucial
in
maintaining reliable dehumidifier operation. The
water tank
holds accumulated condensed water and, by means
of
a safety switch, controls both
the water
level and operation
of
the dehumidification process. When the water tank is full and/or
accidentally displaced inside the cabinet, the float switch actuator (inside the tank) breaks contact
with the safety switch. This condition
results in the immediate shut down of the compressor and fan
motor system, preventing moisture from being condensed.
NOTE: Never tamper with
or
attempt to defeat the water level (safety) float switch system.
10
~
AeonAir.com
AeOnJ,l,1fr
"'
To Next Page
Loading...
Need help?
General