Need help?Do you have a question about the Aerial-51 ALT-512 and is the answer not in the manual?
General| Operating Voltage | 3.3V |
|---|---|
| Modulation | GFSK |
| Interface | SPI |
| Type | RF Transceiver Module |
| Modes | Transmit, Receive |
| Voltage Range | 2.8-3.6 V |
Crucial warning about requiring a license and power supply safety.
Introduction to the ALT-512 SDR transceiver and its key technical data.
List and description of accessories provided with the ALT-512 radio.
Description and function of all buttons and knobs on the front panel.
Explanation of the TFT display elements and side panel connectors.
Explains push/long-push actions and identifies front panel buttons.
Operation of VFO tuning, AF Gain, ON/OFF, UP/DN, and Memory/Tune functions.
Operation of Squelch, Vox, Panadapter, Filter, and Mode buttons.
Configuration of MIC/DIG gain, TX power, and IF settings.
Using the Noise Blanker, Speech Compressor, and DSP Filters.
Adjusting RF Gain, TX meter, and performing a factory reset.
Important initial setup advice and power supply considerations.
Instructions on navigating menu items and adjusting parameters.
Configuration for CW, receiver modes, and transmission settings.
Adjusting Noise Reduction, Notch Filter, and display parameters.
A quick reference table for all software menu items.
To Next Page