Italian
EnglishFrançais
eutsc
spaño
VIEW SINGLE ZONE STATUS
(for each MZC of the system)
MODIFY SINGLE ZONE STATUS
(for each MZC of the system)
MODIFY SINGLE ZONE NAME
(for each MZC of the system)
VIEW OUTDOOR UNIT STATUS
MODIFY OUTDOOR UNIT STATUS
SETTING COMPENSATION WITH EXTERNAL AIR
SETTING TIMED PROGRAM FOR OUTDOOR UNITS
DHW:
This menu contains the functions for viewing the current status of the
DHW circuit and modifying the DHW production parameters. The pages
of this menu are:
VIEW DHW STATUS
MODIFY DHW STATUS
DHW TIMED PROGRAM SETTING
ALARM LOG:
This menu contains information about the last 20 alarms recorded on the
system, and allows you to reset the alarm log. The pages of this menu are:
VIEW ALARM LOG
TIMED PROGRAMS:
This menu contains the functions for setting the timed programs to be as-
sociated with the zones (fancoils and MZCs), and for setting the setpoint
values to be used for heating and cooling. The pages of this menu are:
TIMED PROGRAM SETTING
SETPOINT SETTING
MZC:
This menu contains the functions for viewing the current status of the
zones (where MZC units are installed), and for modifying the unit operating
parameters. The pages of this menu are:
OUTDOOR UNITS:
This menu contains the functions for setting the parameters of the outdoor
units controlled by the VMF system. The pages of this menu are:
INSTALLER MENU (password 404):
This menu contains all the settings needed by the installer during the VMF
system installation and maintenance phases. The pages of this menu are
protected by a password to prevent accidental access to the unit operating
parameters.
WARNING: an incorrect modification of the parameters in this menu
may lead to errors or system malfunctioning, so modifications must
only be made by personal trained in VMF system installation or main-
tenance.
For more information about the installer parameters, refer to the
“VMF System Guide“ on the website, or download it directly using the
following QR code:
2
To Next Page
Loading...
