1
WARNINGS
To use Glider assembly, remove the Universal cap (press finger tabs
to open or use a screwdriver and disengage). Install four line blades
(alternate colors). Make sure lines are properly installed over posts and
onto slots. Connect the Glider cap. Be sure Glider cap and tabs are
fully snapped in place.
fits both
3.5” 5”
Glider assembly cap must be removed. Use hex allen wrench to un-
screw the glider clockwise. Remove button from 5” convertible cap.
With bearing and bolt, install Glider to 5” cap with hex allen wrench.
Hand tighten to 40”# counter-clockwise. Install lines; install assembly
to 5” head receiver. Make sure tabs are securely in place.
The Glider is for ground-supported trimming, which is not a
recommended technique for trimming heavy vegetation.
Do not use the glider for slashing heavy weeds or vines. Remove the
glider and reinstall the stock cap before trimming very tall grass.
Level Cut: rest on the
ground
Low Cut: tilt on the
ground
High Cut: lift o the ground
(manual control)
Corte Nivel: reposo en el
suelo
Corte Bajo: incline sobre
el terreno
Corte Alto: levantarse del
suelo (control manual)
When trimming tall vegetation, start from the top and work your way
down to avoid long strands wrapping in the mechanism.
To minimize the risk of injury from thrown objects, ensure safe shield alignment, and run the
trimmer at lower speeds. Be sure to wear proper eye and body protection.
Protect
bystanders
Flying debris
& blade
contact
Vibration
Do not use
without a
shield
Read/follow
instructions
1
1
2
2
3
3
4
4
1
1
1
2
2
2
5
76 8 9
INSTALLATION, METHODS, & USE
INSTALL THE GLIDER TO YOUR 3.5” AERO-FLEX® UNIVERSAL TRIMMING SYSTEM
INSTALL THE GLIDER TO YOUR 5” AERO-FLEX® CONVERTIBLE TRIMMING SYSTEM
WHEN TO REMOVE THE GLIDER
3.5”
5”
MINIMIZE WRAPPING
Aero-Flex® Glider
UPDATES: www.aero-flex.com
GLIDER TECHNIQUES
VARY CUTTING HEIGHT
AF 7.10.17
To Next Page
Need help?
General