Aeroflex MLS-800 User Manual

Microwave
Landing System
Operation Manual
Issue-3
MLS-800
EXPORT CONTROL WARNING: This document contains controlled
technology or technical data under the jurisdiction of the Export
Administration Regulations (EAR), 15 CFR 730-774. It cannot be
transferred to any foreign third party without the specific prior
approval of the U.S. Department of Commerce Bureau of Industry
and Security BIS). Violations of these regulations are punishable by
fine, imprisonment, or both.

Aeroflex MLS-800 Specifications

General

Brand	Aeroflex
Model	MLS-800
Category	Microwave Oven
Language	English

Summary

Microwave Landing System Operation Manual MLS-800

Export Control Warning

Warning regarding controlled technology and data transfer.

Safety First: To All Operations Personnel

Safety Precautions and Information

Covers safety identification, symbols, grounding, probes, power cords, and fuses.

Introduction

Manual Organization

Outlines the manual's structure into chapters and sections for navigation.

Section 1 - Description

1.1 Description

Overview of the MLS-800-2 as a microprocessor-controlled simulator.

1.2 Functional Capabilities

Lists the simulation capabilities and features of the MLS-800-2.

Section 2 - Operation

1. Installation

Details the step-by-step procedure for installing the Test Set.

1.2 Safety Precautions

Lists essential safety measures to observe during installation and operation.

Controls, Connectors, and Indicators

Front and Rear Panels

Identifies and describes controls, connectors on front and rear panels.

3. Menu Definition

3.1 Power Up Self Test Menu

Displays the results of the self-test performed upon power-up.

3.2 Master Menu

3.4 Test Operational Menu

3.5 Diagnostic Menu

4. Performance Evaluation

4.2 Power Up Self Test

Procedure for verifying the unit's self-test results upon power-up.

5. Operating Procedures

5.1 Keyboard Operating Procedures

Explains how to use the keyboard for data entry, control, and execution.

5.3 Diagnostic Menu Operation

6. Remote Operation (GPIB)

6.1 General

Describes remote communication using the General Purpose Interface Bus (GPIB).

Section 3 - Specifications

1.1 RF Signal Generator

Specifies the technical characteristics of the RF signal generator.

1.2 Modulation

Section 4 - Shipping

1. Shipping Test Sets

Information and procedures for repackaging and shipping test sets.

Section 5 - Storage

1. Storing Test Sets

Precautions for storing the test set for extended periods.

Appendix A - Connector Pin-Out Tables

1. Table of Connectors

Lists connectors, their types, signals, and input/output assignments.

Appendix B - MLS-800-2 Timing Sequences

Normal AZ Cycle

Details the timing sequence for the normal AZ cycle operations.

Appendix C - Channel Frequencies

Appendix D - PFE and CMN Filter Definitions

Appendix H - Abbreviations