Air Coil Nailer MCN70 www.aeroprotools.com
WARNING!
Potential hazard that could result in serious injury or loss of life.
5. Maintenance
Disconnect the tool from the compressor before adjusting, clearing jams, servicing &maintenance, relocating
and during non operation.
Regular lubrication, if your tool without using the in-liner automatic oilier, place 2 or 6 drops of pneumatic
tool oil into the air inlet before each work day or after 2 hours of continuous use depending in the
characteristic of workpiece or type of fasteners.
Air-operated tools must be inspected periodically, and worn or broken parts must be replaced to keep the
tool operating safely and efficiently. Check and change all worn or damaged O-ring, Seals, etc. Tighten all the
To Next Page