What to do if my AEROSPA Swimming Pool power pack does not operate?
If the power pack of your AEROSPA Swimming Pool isn't working, check the power source first. Also, the GFCI might have tripped. If so, reset it and verify that your home's wiring can handle 1500W.
Why is the heating system not working in my AEROSPA Swimming Pool?
Several factors could be preventing your AEROSPA Swimming Pool's heating system from functioning: * The filter cartridge may be dirty; try cleaning or replacing it. * The water level might be too low; add water to the recommended level. * The temperature setting could be too low; adjust it to a higher temperature (between 20-40°C).
How to clean the water in my AEROSPA Swimming Pool?
If the water in your AEROSPA Swimming Pool isn't clean, it could be due to a few reasons. You may need to increase the filtration time. Also, the filter cartridge might be dirty, so try cleaning or replacing it. Finally, ensure you are following the chemical manufacturer’s instructions for proper water maintenance.
What to do if the bubble system isn't working on my AEROSPA Swimming Pool?
If the bubble system on your AEROSPA Swimming Pool isn't working, it might be due to the 30-minute auto shut-off feature. Press the bubble button to reactivate it. Another possibility is that the air pump is too hot. Unplug the air pump, let it cool down, then plug it back in and press the bubble button.
What to do if my AEROSPA Swimming Pool is leaking?
If your AEROSPA Swimming Pool is leaking, check for tears or punctures. If you find any, use the provided repair patch.
General| Brand | AEROSPA |
|---|---|
| Model | PH050006 |
| Category | Swimming Pool |
| Language | English |
To Next Page