2
Safety Rules
Do not switch the air handling unit without grounding.
Before turning the ventilation unit all panels must be closed, and the cover are
in place and secured.
Before turning the ventilation unit its sections must be connected in accordance
with the installation instructions.
Before carrying out an internal inspection unit, make sure the power
supply of ventilation unit is turned off, there are no rotating parts.
Before opening the panel by turning off the unit and main switch, wait (1-2
min.), Until the fans stop.
Air handling unit can only switch on and switch off in ways specified in the device
data sheet.
Be careful when performing installation or repair of water heater -
the coolant temperature can reach 130 ° C!
If the unit is operated with the automation system is not coherent with the plant
manufacturer for the functionality, reliability and safety protection devices
responsible company that installed automation.
The moving parts in the units - a fan impeller, the lock of the bypass valve and plate
heat exchanger (if any). The removable service panels are locked and protected from
direct contact with moving parts. If the outputs of the fan section is not connected to
the air ducts or other sections, these outputs must be covered with a protective mesh.
To Next Page