Need help?Do you have a question about the AERZEN GM 150S and is the answer not in the manual?
General| Type | Rotary lobe blower |
|---|---|
| Connection Size | DN150 |
| Nominal Size | 150 mm |
| Drive | Direct drive |
| Max. Pressure | 1, 000 mbar |
| Speed | 3000 rpm |
| Noise Level | 75 dB(A) |
Installation, piping connection, oil level check, and driving element assembly for the blower stage.
Proper installation in a unit/system, ensuring safety and avoiding housing distortion.
Seal flange connections, avoid dirt ingress, remove covers just before ducting.
Comply with safety regulations, operate in original condition, and ensure electrical safety.
Read instructions before commissioning, use qualified personnel, ensure shutdown system.
Observe warning signs, check for damage, avoid exposed parts, and use suitable tools.
Repairs by professionals, disconnect power before maintenance, and handle materials safely.
Operating without lubricant, with excessive lubricant, soiled filter, or poor ventilation.
Handling dust contamination and gases with solid particles requires specific procedures.
Avoid impact loads, use appropriate lifting gear, and ensure stable suspension.
Install on an even foundation, ensure ventilation, and remove protective plugs.
Top up lubricating oil, check oil level, and verify plug and valve security.
To Next Page
