To code e-TX/remote device: Rotate dial clockwise to CODE
DEVICE then press PB dial. CODE LEARN will display and green LED
will flash indicating coding sequence.
Press e-TX/remote button once > display will show ACCEPT REM 1,
then screen will display CONFIRM REM 1, press e-TX/remote
button one final time and screen will display REM 1 CODED.
To code e-Loop– Method 1: Rotate dial to CODE DEVICE then hold
e-Loop next to the Transceiver antenna. Now press PB dial and
release. Display will show E-LOOP CODED. CODE DEVICE will exit
and return to main screen.
To code e-Loop–Method 2: Rotate dial to CODE DEVICE then press
PB dial, CODE LEARN will be displayed. Now press and release e-
Loop CODE button. Screen will display E-LOOP CODED and will exit
back to main screen,(for commercial e-Loop, use the magnet
provided to activate the CODE button)
NEED MORE ASSISTANCE?
+44 (0)288 639 0693
SCAN THIS QR CODE TO BE BROUGHT TO OUR RESOURCES PAGE.
VIDEOS | HOW-TO GUIDES | MANUALS | QUICK START GUIDES
Ensure e-Trans is not in a steel/metal enclosure which can reduce
signal range.
The transceiver should be mounted as high as
possible with clear line of sight to loop to maximise range.
Check out our YouTube
channel for how to
guides
e-Trans 200 Connection Diagram
1
Coding devices:
STILL HAVING TROUBLE?
Find all of our support options such as Web Chat,
Full Manuals, Customer Helpline and more on
our website:
WWW.AESGLOBALONLINE.COM
* ALWAYS TEST THE UNIT ON SITE BEFORE INSTALLATION TO AVOID RE-STOCKING FEE * See full T&C’s on our website
10-36V ACDC
Output
Open/Start
Input
YouTube
Full Manual
1.5M Detection zone
from centre of e-Loop
Open/Start
Input
Gate
control
board
Gate
control
board
Technical Specs:
Quick Start Guide
e – Trans 200
To Next Page
Need help?
General