Step 6: Check the button function. Push the beep
button, the receiver will produce beeping sound and
similarly, push the vibrate button, it will cause
vibration. Cap the shock test kit on the metal prongs,
and push the shock button. If the bulb lights up, the
shock function is ok.
6
8
Step 9 : Start to train. Put the collar into the receiver and wear the
receiver around dog’s neck. Remember to leave one finger place
between collar and neck, then it’s ready to train.
Quick Start
-03-
Step 7: Adjust the intensity of shock function
by rotating the thumbwheel dial.
Tip 3: Longer(shorter) holding beep, vibrate or shock button
will lead to longer (shorter) duration of beep, vibrate or
shock time.
0
9
0
9
Step 8: Choose the dog mode (Dog1, dog2 or dog00). By
pushing the dog switch button in the left of the transmitter, you can
train different dogs separately by synced the receiver one by one.
If Dog00 is selected, both dogs will receive correctional signals.
Tip 5:Auto Anti Bark function which default setting is off is available.
Press Dog Switch button for 3 seconds , then the signal button will
light up with BLUE LED which means the auto anti bark function is
turned on. Do it again, the Auto Anti Bark function will be turned off.
You can alter receivers' auto anti bark status(ON or OFF
simultaneously) in dog 00 system, both receivers' initial setting will
probably be changed. In this case, when you go back to the other 2
systems, remember to push one of function buttons to update the
auto anti bark status in the current dog system; After updated anti
bark status, the signal button will tell you what the exact anti bark
status is. Please turn auto anti bark function off timely when not in
use.
⑦
Tip 4: To do a self-test,press the On/Off button of receiver three
times it should beep, vibrate and shock, indicating afunctional unit.
To Next Page
Loading...
