aevit VIC 2.0 - Page 10


INSTALLATION STEP 10 - INSTALLING THE VIC 2.0 MICROPHONE
35
VIC 2.0 INSTALLATION
VIC 2.0
MICROPHONE
FINE ADJUSTMENT
SECTION
GROSS ADJUSTMENT
SECTION
MICROPHONE
WIRE
BASE PLATE
VIC 2.0
It is necessary to position the microphone with the client1. in the vehicle:
VIC 2.0

Avoid sharp bends of the Gross adjustment section of the microphone:2.
CORRECT INCORRECT
The microphone should be as un-intrusive as possible:3.


       
        
         







