AFG 4.1AE - Pre-Assembly and Unpacking

TOOLS INCLUDED:
[] 8 mm L-Wrench
[] 5 mm L-Wrench
[] 13/15 mm Flat Wrench
[] Screwdriver
[] 5 mm L-wrench/Screwdriver
PARTS INCLUDED:
[] 1 Stabilizer Tube
[] 1 Guide Rail Set
[] 2 Pedal Arms
[] 2 Lower Handlebars
[] 2 Upper Handlebars
[] 2 Lower Link Arms With Footpads
[] 1 Top Cap (2 pieces)
[] 1 Console Mast
[] 1 Console Mast Boot
[] 1 Console
[] 2 Handlebar Caps
[] 1 Water Bottle Holder
[] 1 Rear Cover
[] 1 Audio Adapter Cable
[] 1 Power Cord
[] 1 Hardware Kit
3.1AE only:
[] 2 Handlebar Boots
4.1AE only:
[] 2 Handlebar Covers
[] 2 Aero Hand Grips
[] 1 iPod:" Dock Rubber Plug
[] 1 Polar:" Chest Strap
PRE ASSEMBLY
UN PAC KI NG
Unpack the product where you will be using it. Place the elliptical carton on a level
flat surface. It is recommended that you place a protective covering on your floor.
Never open box when it is on its side.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place
and partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any
grease, such as lithium bike grease is recommended.
_' NEED HELP?
If you have questions orif
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.