AFG 5.3AE - Assembly Step 10 (7.3 AE); Elliptical Operation and Console

2120
ELLIPTICAL OPERATION
This section explains how to use your elliptical’s console and programming.
The BASIC OPERATION section in the ELLIPTICAL GUIDE has instructions for the following:
• LOCATION OF THE ELLIPTICAL
• POWER/GROUNDING INSTRUCTIONS
• FOOT POSITIONING
• MOVING THE ELLIPTICAL
• LEVELING THE ELLIPTICAL
• POWER/MANUAL INCLINE OPERATION
• USING THE HEART RATE FUNCTION
7.3AE
19
22
21
11
20
18
ASSEMBLY STEP 10 (7.3AE)
If you would like to use the elliptical without the
UPPER HANDLEBARS (19), you can install the
HANDLEBAR COVERS (21) instead.
NOTE: All hardware for this step is included in the
plastic bag with the HANDLEBAR COVERS.
A If the UPPER HANDLEBARS (19) are
already installed, remove the PRE-
INSTALLED SCREWS (20) and slide
off the UPPER HANDLEBARS (19) and
HANDLEBAR BOOTS (18) from the LOWER
HANDLEBARS (11).
B Remove 2 HANDLEBAR COVERS (21) and
SCREWS (22) from plastic bag.
C Place HANDLEBAR COVERS (21) over the
LOWER HANDLEBARS (11) and attach using
2 included SCREWS (22).
AFG14_3.3AE_5.3AE_7.3AE_OM_r1_4.indd 20-21 5/20/14 9:12 AM