Need help?Do you have a question about the AFP Imaging IMAGE-VET 70 ACP and is the answer not in the manual?
Describes system function, standards, and disposal instructions.
Covers safety symbols, ambient conditions, and radiation safety.
Details the X-ray system, arms, tubehead, and control panel.
Lists details found on various equipment labels.
Describes patient positioning, techniques, and control panel use.
Guides on selecting exposure time and film sensitivity.
Provides tables for exposure times and corrections.
Covers manual processing, automatic, and defect identification.
Details cleaning, disinfection, and routine checks.
Lists error codes and system parameters.
Lists fuse IDs, ratings, and protected parts.
Covers initial steps, tools, and requirements before installation.
Details steps for mounting the wall plate, timer, arms, and tubehead.
Covers wiring the control unit and jumper settings.
Steps to prepare the tube and check power supply.
Outlines diagnostic tests and voltage verification.
Covers wiring faults and specific operational tests.
Details friction and balance adjustments for arms.
Lists electrical and electro-mechanical components with part numbers.
Describes assembly, maintenance, and tubehead removal.
General| Power Requirements | 110V, 60Hz, 15A |
|---|---|
| Film Sizes | Up to 14 x 17 inches |
| Processing Time | Approximately 90 seconds |
| Focal Spot Size | N/A (Film Processor) |
| Anode Heat Capacity | N/A (Film Processor) |
| Cooling System | N/A (Film Processor) |
| Weight | Varies by configuration |
To Next Page