AFWFilters Fleck 5600 - User Manual

Installation Instructions for Water Softeners with Fleck 5600 and
5600SXT
Covers standard water softeners using a
separate brine tank.
THANK YOU
Thank you for purchasing a new Water Softener from AFWFilters. We appreciate the
opportunity you have given us to provide you with better water. We are committed to
providing the best customer experience possible and have provided these installation
instructions to make things as simple as possible. If you have read through these entire
instructions and FAQ section and still have questions feel free to contact us for further
help.
BEFORE YOU BEGIN
BASIC PLUMBING SKILLS ARE REQUIRED FOR INSTALLATION. IF YOU ARE UNSURE
OF YOUR ABILITIES TO INSTALL THE SYSTEM USING THESE INSTRUCTIONS PLEASE
HIRE A QUALIFIED PLUMBER.
READ THROUGH YOUR PARTS LIST AND VERIFY ALL COMPONENTS ARE ACCOUNTED
FOR AND IN GOOD CONDITION BEFORE SCHEDULING A PLUMBER.
PLEASE READ THROUGH THE ENTIRE INSTRUCTION MANUAL CAREFULLY. IF HIRING
A PLUMBER ENSURE THEY HAVE A COPY BEFORE THEY START.
MOST COMMON QUESTIONS ARE ANSWERED IN THE INSTRUCTIONS OR FAQ
SECTION. IF YOU HAVE READ BOTH OF THOSE AND STILL HAVE QUESTIONS YOU
MAY CONTACT US FOR FURTHER HELP.
PLUMBING RELATED QUESTIONS NEED TO BE DIRECTED TO A LOCALLY QUALIFIED
PLUMBER. WE ARE NOT PLUMBERS AND ANY PLUMBING QUESTIONS WE RECEIVE
WILL NOT BE ANSWERED.
1 of 28

Summary

SYSTEM REQUIREMENTS

2-PRE-INSTALLATION PREPARATION

2.1-Verify riser tube position

2.3-Load resin and gravel-GRAVEL GOES IN FIRST

Critical step to load gravel first, then resin, into the polyglass tank.

3-ATTACH THE CONTROL HEAD

3.1-Lubricate the O-rings DO NOT USE VASELINE

Lubricate tank and pilot O-rings with silicone lubricant or vegetable oil only.

3.2-Inspect and install top distributor basket if applicable

3.3-Screw on control head HAND TIGHT ONLY

Screw head down until solid contact, tighten 1/4-1/3 turn. Do not overtighten.

4-PREPARE AND CONNECT BRINE TANK

4.1-Assemble the brine tank

4.2-Use 3;8 inch line to connect brine tank to control head

4.4-Add salt to the brine tank, water is not necessary

5-SETUP CONTROL HEAD

5.1-Plug control head in

Connect the control head to a qualifying outlet and verify power.

5.2-DIGITAL CONTROLLER - Initial valve setup

Initial programming by setting the clock to 12:01pm to enter master programming.

5.3-DIGITAL Controller - Resets

Procedures for soft and hard resets to resolve controller issues.

5.4-MECHANICAL CONTROLLER - Frequency

Calculating and setting system frequency based on water hardness and capacity.

5.5-MECHANICAL CONTROLLER - Time

Setting the 24-hour time gear for regeneration cycles.

6-PLUMBING GUIDELINES

6.1-Drain Line Connection

Connect the drain line with a physical air gap to avoid contamination, never tie multiple systems together.

6.2-Inlet;Outlet Connections

Ensure correct flow direction for inlet/outlet connections to prevent damage.

7-PLACE SYSTEM IN SERVICE

7.1-Open bypass valve SLOWLY

Slowly open bypass valve to bleed air, then fully open once tank is full.

7.2-CHECK FOR LEAKS

Check all connections for leaks, especially between tank and control head.

7.3-Flush the system

7.4-Initiate manual regeneration

7.5-Verify proper operation

SXT Error Codes

0 Cam Sense Error

1 Cycle Step Error

2 Regen Failure

3 Memory Error

AFWFilters Fleck 5600 Specifications