Identification of the machine
The AG Maxi is i
dentified by the Serial Plate, s
manufacture,
1.
Before fitting the AG Dispenser to the prime mover, check that the combined
weight of the AG Dispenser and the heaviest load does not
manufacturer’s
recommended safe loading of the front and rear axle, wheels and
tyres.
2. E
nsure that the combined load is within the lifting capacity of the prime mover.
3.
If the AG Dispenser is mounted on a 3 point linkage then also ensure that
is enough counter balance from the prime mover to compensate the load without
exceeding the load capacity of the prime mover.
WARNING. THE OPERATOR IS RESPONSIBLE FOR
TOGETHER A SAFE AND STABLE WORKING UNIT UNDER
ALL EXPECTED WORKING CONDITIONS.
5
Identification of the machine
dentified by the Serial Plate, s
howing – product,
eight.
Before fitting the AG Dispenser to the prime mover, check that the combined
weight of the AG Dispenser and the heaviest load does not
recommended safe loading of the front and rear axle, wheels and
nsure that the combined load is within the lifting capacity of the prime mover.
If the AG Dispenser is mounted on a 3 point linkage then also ensure that
is enough counter balance from the prime mover to compensate the load without
exceeding the load capacity of the prime mover.
WARNING. THE OPERATOR IS RESPONSIBLE FOR
THE PRIME MOVER AND SCRAPER ARE
TOGETHER A SAFE AND STABLE WORKING UNIT UNDER
ALL EXPECTED WORKING CONDITIONS.
Before fitting the AG Dispenser to the prime mover, check that the combined
weight of the AG Dispenser and the heaviest load does not
exceed the
recommended safe loading of the front and rear axle, wheels and
nsure that the combined load is within the lifting capacity of the prime mover.
If the AG Dispenser is mounted on a 3 point linkage then also ensure that
there
is enough counter balance from the prime mover to compensate the load without
WARNING. THE OPERATOR IS RESPONSIBLE FOR
THE PRIME MOVER AND SCRAPER ARE
TOGETHER A SAFE AND STABLE WORKING UNIT UNDER
To Next Page
Loading...
