AG 150 - Page 9

AG MODEL
150
175
200
If the machines are to be used on prime movers with limited oil flow, the AG dispensers
can be modified to suit, using
Three speed settings are obtainable
125-125 ratio
140-
80 ratio (as shown in Fig 3)
140-60 ratio
The hydraulic motor DH25, can also be changed for a higher speed output motor.
Consult your local dealer.
NB. Higher speed settings are designed for low oil flow settings, using
them on
higher oil flow machines will invalidate warranty.
9
OIL FLOWS
Oil flow requirement:
15-60 l/min
15-60 l/min
15-60 l/min
If the machines are to be used on prime movers with limited oil flow, the AG dispensers
can be modified to suit, using
a selection of pulley ratios.
Three speed settings are obtainable
-
Standard
80 ratio (as shown in Fig 3)
Suitable for low to medium flows
Suitable for low oil flows
The hydraulic motor DH25, can also be changed for a higher speed output motor.
NB. Higher speed settings are designed for low oil flow settings, using
higher oil flow machines will invalidate warranty.
If the machines are to be used on prime movers with limited oil flow, the AG dispensers
Fig 3.
Suitable for low to medium flows
The hydraulic motor DH25, can also be changed for a higher speed output motor.
NB. Higher speed settings are designed for low oil flow settings, using