AG 150 - Page 10

Slider regulator
All the AG Dispensers are supplied with adjustable slides
the flow of material through the machine.
AG 150
Sawdust (FINE) 100 M
m
Sawdust 100-
150
Paper(DRIED) 150-
100
Paper 200-
250
Sand 200-
300
T
o adjust loosen nuts and bolts. Part 35, 37)
1.
Reduce each hole by an equal amount.
2.
Reduce by a small amount each time, then run and test.
3.
Enlarge holes towards the centre of the
If a machine runs in one direction for a short period of time and then stops,
then in the other direction fora short period of time and stops. The holes in
the slide need enlarging towards the
10
ADJUSTMENTS
All the AG Dispensers are supplied with adjustable slides
that
are designed to regulate
the flow of material through the machine.
AG 150
AG 175
AG 200
m
100mm 100
m
150
Mm 100-150 mm 100-
150
100
Mm 150-200 mm 150-
200
250
Mm 200-250 mm N/A
300
Mm 200-300*200 mm N/A
Fig 4.
o adjust loosen nuts and bolts. Part 35, 37)
Reduce each hole by an equal amount.
(by moving slide(38))
Reduce by a small amount each time, then run and test.
Enlarge holes towards the centre of the
slide.
If a machine runs in one direction for a short period of time and then stops,
then in the other direction fora short period of time and stops. The holes in
the slide need enlarging towards the
centre of the slide.
Remove slide form machine.
Ensure that the AG machine is
secure and
the prime mover is
turned off, with the hand brake
applied.
are designed to regulate
AG 200
m
m
150
mm
200
mm
If a machine runs in one direction for a short period of time and then stops,
then in the other direction fora short period of time and stops. The holes in
Remove slide form machine.
Ensure that the AG machine is
the prime mover is
turned off, with the hand brake