12 13
Galvanic Spa Facial Gels
with ageLOC
Pre-Treat Setting Treatment Setting Conductor
Use this regimen three-times each week for visibly revitalising
& refreshing results.
Preparation: Use after a Nu Skin
®
cleanser
of your choice. Attach the ageLOC Face
Conductor to the device
Figure 1).
GS
PRETREAT GEL
PRETREAT GEL PHASE
step 1: Evenly apply an entire ampoule of
ageLOC Pre-Treat Gel to the entire face
and neck, avoiding eyes, eyelids, and lips.
step 2: Push the selection button until the
number 1 is lit on the display
Figure 2). This
application will take 2 minutes.
step 3: Thoroughly wet hands with NaPCA
Moisture Mist or water. Hold the device with
a moistened hand while touching the chrome
plate on the back and begin to slowly glide the
conductor head over your skin
Figure 3). Be
sure to avoid sensitive areas like your eyes,
eyelids, and lips.
The device will beep once, twice, or three times to indicate that
it has automatically adjusted to your skin. After this, your galvanic
application has begun, and the device will beep every 10
seconds to indicate the unit is on and working, and every 5
seconds when your application is almost complete.
step 4: When your galvanic application
is over, the device will emit a long beep
followed by two short beeps and
automatically turn o. Remove any
remaining gel from your skin and the
device with a damp towel
Figure 4).
Now it
’
s time for the Treat Gel phase.
TREATMENT GEL PHASE
step 1: Apply an entire ampoule of
ageLOC Treatment Gel to your face and neck.
step 2: The ageLOC Face Conductor should already be
attached, so press the selection button once to turn the
device back on and keep pressing until you
select application number 2
Figure 5).
This application will take 3 minutes.
step 3: Again, hold the device with a
moistened hand while touching the chrome
plate on the back, and begin to slowly glide
the conductor head over your skin
Figure
6). Be sure to avoid sensitive areas like your
eyes, eyelids, and lips.
The device will beep one, two, or three
times to indicate that it has automatically
adjusted to your skin. After this, your galvanic
application has begun, and the device will
beep every 10 seconds to indicate the unit is
on and working, and every 5 seconds when
your application is almost complete.
step 4: When your galvanic application is over, the device will
emit a long beep followed by two short
beeps and automatically turn o. Use a
damp towel to remove any remaining gel
from your skin and the device
Figure 7).
Figure 2
Figure 3
Figure 5
Figure 6
Figure 7
Figure 4
GS
TREATMENT GEL
EN EN
Figure 1
To Next Page
Loading...
