Agilent Technologies, Inc. 7.NC.NL.A.11.03.97.R1.P.CW6FC
900 South Taft Avenue
Loveland, Colorado 80537 U.S.A.
Copyright 1994 - 2009
Agilent Technologies, Inc.
All Rights Reserved. Reproduction,
adaptation, or translations without
prior written permission is
prohibited, except as allowed under
the copyright laws.
March 2009
Printed in Malaysia
Manual part number
53131-90039
Certification and Warranty
Certification
Agilent Technologies certifies that
this product met its published
specification at the time of shipment
from the factory. Agilent
Technologies further certifies that its
calibration measurements are
traceable to the United States
National Institute of Standards and
Technology (formerly National
Bureau of Standards), to the extent
allowed by the Institute’s calibration
facility, and to the calibration
facilities of other International
Standards Organization members.
Warranty
Agilent warrants Agilent hardware,
accessories and supplies against
defects in materials and
workmanship for a period of one year
from date of shipment. If Agilent
receives notice of such defects during
the warranty period, Agilent will, at
its option, either repair or replace
products which prove to be defective.
Replacement products may be either
new or like-new.
Agilent warrants that Agilent
software will not fail to execute its
programming instructions, for the
period specified above, due to
defects in material and workmanship
when properly installed and used. If
Agilent receives notice of such
defects during the warranty period,
Agilent will replace software media
which does not execute its
programming instructions due to
such defects.
For detailed warranty information,
see back matter.
Safety Considerations
General
This product and related
documentation must be reviewed for
familiarization with this safety
markings and instructions before
operation.
Before Cleaning
Disconnect the product from
operating power before cleaning.
Warning Symbols That May Be
Used In This Book
Instruction manual symbol; the
product will be marked with this
symbol when it is necessary for the
user to refer to the instruction
manual.
Indicates hazardous voltages.
Indicates earth (ground) terminal.
or
Indicates terminal is connected to
chassis when such connection is not
apparent.
Indicates Alternating current.
Indicates Direct current.
Safety Considerations (contd)
ARNING
BODILY INJURY OR DEATH
MAY RESULT FROM
FAILURE TO HEED A
WARNING. DO NOT
PROCEED BEYOND A
WARNING UNTIL THE
INDICATED CONDITIONS
ARE FULLY UNDERSTOOD
AND MET.
AUTION
Damage to equipment, or incorrect
measurement data, may result
from failure to heed a caution. Do
not proceed beyond a CAUTION
until the indicated conditions are
fully understood and met.
Safety Earth Ground
An uninterruptible safety earth
ground must be maintained from the
mains power source to the product’s
ground circuitry.
ARNING
WHEN MEASURING POWER
LINE SIGNALS, BE
EXTREMELY CAREFUL AND
ALWAYS USE A
STEP-DOWN ISOLATION
TRANSFORMER WHICH
OUTPUT IS COMPATIBLE
WITH THE INPUT
MEASUREMENT
CAPABILITIES OF THIS
PRODUCT. THIS PRODUCT’S
FRONT AND REAR PANELS
ARE TYPCIALLY AT EARTH
GROUND. THUS, NEVER TRY
TO MEASURE AC POWER
LINE SIGNALS WITHOUT AN
ISOLATION TRANSFORMER.
For additional safety and acoustic
noise information, see back matter.
To Next Page
Loading...
Need help?
General
