Agilent Technologies 8504B - Page 168

FINAL TRIM SIZE : 7.5 in x 9.0 in
Programming
Instrument Commands
OUTPFORM
Outputs
the
formatted
trace data.
Format
depends on
the
current
setting
for
display
format.
Syntax
OUTPFORM
OUTPIDEN
Outputs
the
identication
string,
HEWLETT PACKARD,
HP 8504B,0,X.XX
,
where
X.XX
is
the
rmware revision.
This command
is identical
to the
IDN?
command.
Syntax OUTPIDEN
OUTPKEY
Outputs
the
key
code
of
the
last
key pressed.
An invalid
key is
outputted
with
63,
a
knob
turn
with
-1.
Syntax
OUTPKEY
Refer
to the
KEY command
in
this
chapter
for
a
gure
that
shows
the
key
codes
that correspond
to front-panel
keys
.
OUTPLEAS
Outputs
the
learn
string,
which
contains
the
current
instrument
state
of
the
reectometer
.
Syntax
OUTPLEAS
OUTPLIMF
Outputs the
limit
test
results
only
for
the
failed
points
.
Data
format
position,
result
(0
for
fail,
-1
for
no
test),
upper
limit,
lower
limit;
F
orm
4)
Syntax
OUTPLIMF
OUTPLIML
Outputs the
limit test
results for
each point.
Data
format
position,
result
(1
for
pass
,
0
for
fail,
-1
for
no
test),
upper
limit,
lower
limit;
This
is
always
a
F
orm
4,
ASCII,
transfer
,
regardless
of
the
FORM
command
already
set.)
Syntax OUTPLIML
OUTPLIMM
Outputs the limit
test result for the maker position. (Data format position,
result (1 for
pass, 0 for fail, -1 for no test), upper limit, lower limit)
Syntax OUTPLIMM
4-41
All manuals and user guides at all-guides.com