Agilent Technologies 8504B - Step 2: Connect the Two Instrument Sections

FINAL TRIM SIZE : 7.5 in x 9.0 in
Step
2.
Connect
the two
instrument sections
W
A
R
N
I
N
G
Always
disconnect
and
separate
the
two
instrument
sections
before
lifting
or
moving
the
instrument.
Otherwise
,
you
may
harm
yourself
or
damage
the
instrument.
1.
Verify
that
serial
number
labels
on
the
two
instrument
sections
contain
the
same serial
number
.
Y
ou'll
nd
these
labels
on
the
precision
reectometer's
rear
panel.
Make
sure
that
the
serial
number
and
options
listed
on
the
labels
match
the
serial
number
and
options
listed
on
the
shipping document.
2.
Place
the lightwave
section on
a steady
, sturdy
work
surface
.
3. Place
the
display
processor
on
top
of
the
lightwave
section
so
that
the
front edge
of
the
display
processor
is
about
0.6
cm
(0.25
in)
in
front
of
the
lightwave section.
4. Slightly lift the
rear of the display processor and slide it back until its front
edge is even with the
front edge of the lightwave section.
1-5
All manuals and user guides at all-guides.com