Hardkey and Softkey Reference ESG Family Signal Generators
Sweep/List
4-102 User’s Guide
Immediate
This softkey is one of the choices in both the Sweep Trigger menu and
the Point Trigger menu. Press either the
Sweep Trigger softkey or the
Point Trigger softkey to view these menus. Choosing Immediate in the
Sweep Trigger menu immediately triggers the current sweep when you
press the
Single Sweep softkey. When sweep repeat is continuous and
Immediate is chosen for the sweep trigger, then sweeps are triggered
consecutively (a new sweep is triggered as soon as the current sweep
ends). Choosing
Immediate in the Point Trigger menu causes the sweep to
pause for the dwell time at each point after the hardware has been set
up for that point’s frequency and amplitude.
Softkey Location:
Sweep/List > Sweep Trigger > Immediate
Or: Sweep/List > Point Trigger > Immediate
Insert Item
Press this softkey to place a copy of the selected item directly below that
item in the sweep list. First use the up and down arrow keys until the
item you wish to copy is selected. Press
Insert Item and an identical copy
of the selected item is placed below it.
Softkey Location:
Sweep/List > Configure List Sweep > Insert Item
Insert Row
Press this softkey to place a copy of the selected row directly below that
row in the sweep list. First use the up and down arrow keys until any
item is selected in the row you wish to copy. Press
Insert Row and an
identical copy of the selected row is placed below it.
Softkey Location:
Sweep/List > Configure List Sweep > Insert Row
Load From Selected File
Press this softkey to load the list sweep data from a file into the current
sweep list. Use the arrow keys to highlight the desired sweep list file.
Press
Load From Selected File and the list sweep data from the selected file
is loaded into the current list sweep. You can only have one list sweep at
a time so the existing list sweep data will be lost unless it is first stored
to a file. This softkey is inactive unless at least one list sweep data file
has been stored to memory.
Softkey Location:
Sweep/List > Configure List Sweep > Load/Store >
Load From Selected File
To Next Page
Loading...
Need help?
General
