6 Memory
6.18 NandFlash3 Retention(WrittenCell): NAND flash memory cell Data
retention test after Write (A.03.10)
[Supported Analyzer]
B1500A
[Description]
Performs the data retention test for the NAND type flash memory cell after the write operation, and plots the
accumulated time vs threshold voltage characteristics.
[Device Under Test]
NAND-type flash memory cell
[Required Modules and Accessories]
Agilent B1525A SPGU 1 unit
Selector (16440A/16445A 1 set or HRSMU/ASU 1 set)
[Device Parameters]
Lg: Gate length
Wg: Gate width
Temp: Temperature
IdMax: Drain current compliance
[Test Parameters]
Gate: SMU connected to Gate terminal, primary sweep voltage output
Drain: SMU connected to Drain terminal, constant voltage output
Source: SMU connected to Source and Substrate terminals, constant voltage output
Pgate: SPGU channel connected to Gate terminal via Selector
VgStart: Sweep start voltage for Gate terminal
VgStop: Sweep stop voltage for Gate terminal
VgStep: Sweep step voltage for Gate terminal
Vd: Drain voltage
Id@Vth: Drain current to decide the Vth
IntegTime: Integration time
PulsePeriod: Write pulse period
PulseDelay: Write pulse delay
PulseWidth: Write pulse width
Vwrite: Write pulse output level
LeadingTime: Pulse leading edge transition time
TrailingTime: Pulse trailing edge transition time
TotalRetentionTime: Time to continue the test. 10 to 10000 seconds
MeasTiming: Timing to perform Vth measurement
[Extended Test Parameters]
Vs: Source voltage
IgLimit: Gate current compliance
HoldTime: Hold time
DelayTime: Delay time
BaseValue: Write pulse base value
NoOfPulse: Number of output pulses for the write operation
DrainMinRng: Minimum range of drain current measurement
[Measurement Parameters]
Agilent EasyEXPERT Application Library Reference, Edition 8
6-39
To Next Page
Loading...
