Agilent Technologies EasyEXPERT

19 WGFMU_IV
19.2 WGFMU Id-Vd (DC) (A.05.03.2013.0124_2013.03.26.1)
[Supported Analyzer]
B1500A
[Description]
Measures the drain current vs drain voltage characteristics of MOSFET using WGFMU
[Device Under Test]
MOSFET
[Device Parameters]
Lg: Gate Length
Wg: Gate Width
Temp: Temperature
[Test Parameters]
Period: Pulse period
Drain: WGFMU connected to Drain, primary sweep voltage output
VdStart: Sweep start voltage for Drain
VdStop: Sweep stop voltage for Drain
VdStep: Sweep step voltage for Drain
Gate: WGFMU connected to Gate, secondary sweep voltage output
VgStart: Sweep start voltage for Gate
VgStop: Sweep stop voltage for Gate
VgStep: Sweep step voltage for Gate
MeasRange: Measurement range for drain current
RiseTime: Rise time of each step
Hold: Hold time
MeasDelay: Measurement delay time
AveragingTime: Measurement averaging time
[Extended Test Parameters]
DataDisplay_PatternValidation : PatternValidation data display mode (Not effective for Pattern Validation
mode)
Disable (does not display PatternValidation data during measurement)
Enable_Waveform_MeasTiming (displays Waveform and MeasTiming during measurement)
ExecutionMode: Execution mode
Run Vector: Performs the waveform output and measurement
Pattern Validation: Displays the waveform and measurement
[Measurement Parameters]
Id: Drain current
[X-Y Plot]
X axis: Vd, Drain voltage (LINEAR)
Y1 axis: Id, Drain current (LINEAR)
[List Display]
Vd, Drain voltage
Agilent EasyEXPERT Application Library Reference, Edition 8
19-4