Agilent Technologies EasyEXPERT

19 WGFMU_IV
19.6 WGFMU PLSDIV (A.05.03.2013.0124_2013.03.26.1)
[Supported Analyzer]
B1500A
[Description]
Ch1 and Ch2 measures current or voltage with Ch1 sweeping pulsed output, and Ch2 constant output
[Test Parameters]
PulsePeriod: Pulse period
[Ch1 and Ch2]
ChX: WGFMU channel to use
ChXOperationMode: Operation mode
PG Vmeas (PG mode, voltage measurement)
Fast IV Imeas (Fast IV mode, current measurement)
Fast IV Vmeas (Fast IV mode, voltage measurement)
ChXVForceRange: Voltage output range
Auto, 3V, 5V, -10V to 0V, or 0V to 10V
ChXMeasRange: Measurement range
For current measurement: 1uA, 10uA, 100uA, 1mA, or 10mA
For voltage measurement: 5V or 10V Ch1VStart: Ch1 start voltage
ChXPulseBase: Pulse base voltage
ChXPulseDelay: Pulse Delay
ChXPulseRiseTime: Pulse Rise Time
ChXPulseWidth: Pulse width
ChXPulseFallTime: Pulse Fall Time
Ch1VStart: Sweep start voltage of pulse top
Ch1VStop: Sweep stop voltage of pulse top
Ch1VStep: Sweep step voltage of pulse top
Ch2VConst: Constant voltage of pulse top
Hold: Hold time
MeasDelay: Measurement delay time
AveragingTime: Measurement averaging time
For detailed timing information, please scroll down to the bottom of Test Parameters window.
[Extended Test Parameters]
DataDisplay_PatternValidation : PatternValidation data display mode (Not effective for Pattern Validation
mode)
Disable (does not display PatternValidation data during measurement)
Enable_Waveform_MeasTiming (displays Waveform and MeasTiming during measurement)
ExecutionMode: Execution mode
Run Vector: Performs the waveform output and measurement
Pattern Validation: Displays the waveform and measurement setup, for debugging
Agilent EasyEXPERT Application Library Reference, Edition 8
19-12