Need help?Do you have a question about the Agit Wave Storm and is the answer not in the manual?
General| Brand | Agit |
|---|---|
| Model | Wave Storm |
| Category | Sports & Outdoors |
| Language | English |
Remove the fin when transporting the board to prevent damage.
Rinse your board with fresh water after every use to remove dirt, sand, and salt residue.
Store your board away from direct sunlight, in a cool, dry location.
Use non-solvent glue to repair foam surface holes, scratches, or side rail seams.
Slide the metal plate forward in the fin box as shown in the diagram.
Insert the fin into the fin box, slide it backwards into position, and push it down.
Attach the fin to the metal plate with a screw, adjusting position as needed.
Pull the leg leash rope through the eyelet as shown in the diagram.
Pull the leg cuff through the leg leash rope as shown in the diagram.
Pull the leg leash rope tight to complete the leash installation.
Measure from your feet to 4 inches above your head to determine the ideal paddle length.
Remove the handle, cut the paddle tube to the desired length, and smooth edges.
Mix glue, apply to handle stem, insert into paddle tube, and hold for 5 minutes.
To Next Page