10 FOOT 6 STAND UP PADDLE BOARD
10 FOOT 6 STAND UP PADDLE BOARD
STEPS FOR ADJUSTING PADDLE LENGTH
Use a Tape Measure to determine proper length. Measure from the
bottom of your feet(floor) to 4” above your head. This measurement
should be good for determining the overall length of your new Paddle.
Each user has different preferences, so be sure this length works for
you before applying the glue. This process is only meant help assist
you determine what overall length should work for you. Keep in mind,
cutting the tube & applying glue are permanent procedures, so be very
sure of your measurements.
Cut Paddle tube with a hack saw. Then use the included nail file to
smooth edges of your cut.
RE-ATTACHING HANDLE TO PADDLE TUBE
CONTACT CUSTOMER SERVICE IF YOU HAVE ANY QUESTIONS
Your new Paddle as it comes inside the box, measures 82” (208cm)
, you can adjust the Paddle length to
properly fit your desired length. However, if you choose not to adjust
Paddle length, then move directly to Step-D.
• PLEASE USE GLUE WITHIN 60 SECONDS AFTER MIXING.
• PLEASE KEEP GLUE KIT IN DRY, COOL PLACE FOR STORAGE.
• KEEP OUT OF REACH OF CHILDREN.
• WASH HANDS THOROUGHLY WITH SOAP AND WATER AFTER APPLICATION.
1
Protect your work area from excess glue dripping from the following process.
2
Wipe clean the joint surfaces of Paddle tube & Handle to be joined.
3
Mix glue (A) & (B) well with equal portions.
4
Apply mixed glue to outer surface of Handle stem only.
5
Instert Handle stem into Paddle tube & make sure the silver lines match up.
6
Hold into position for 5-minutes.
7
After 5-minutes, continue allowing glue to dry properly for 30-minutes
8
Remove loose Handle from top of Paddle tube. Measure the amount of
tubing to be removed to achieve your desired Paddle length.
To Next Page
Loading...