Agora Bismarck - Page 4

03 04
05 06
07 08
2102
PB
2106
2103
2101
2102
2105
2101
2104
2104
Turn the deck pieces over, keeping the decking in
place, and fix together from the underside using four
PB 2 x 5mm screws.
Check the fit of the starboard protective wall 20-03
on the deck 20-01. When you are happy with the fit,
apply a tiny bit of superglue to the studs on the lower
edge of the wall 20-03 and fix in place.
Repeat step 4 to fix the port protective wall in place
on the other side of the deck.
Remove the two skylights 21-05 from the frame.
File away any unevenness where they were
connected to the frame (inset). Check the fit of the
skylights on the deck, inside the protective walls.
Glue in place as shown.
Cut the four barrel containers 21-04 from their frame.
Check the fit of the containers – the pegs on the
containers fit into the holes in the decking 20-01.
Apply a little superglue to the pegs on the containers
and glue them in place on the deck, as shown.
2101
4
4
AGORAMODELS BISMARCK
PB
AGORAMODELS BISMARCK