存放
Storage
6.4 液压悬挂系统调整
Hydraulic hitch system adjustment
6.4.1 提升器的调整
Adjustment of hydraulic hitch system
前驱动桥最终传动的调整见图。
Final drive system adjustment of front axle refers
to the figure.
前驱动桥最终传动的 2 个圆锥滚子轴承 7 是预紧
的。检查调整时先拆下螺栓 1，取下行星架 2，
将调节螺母 3 拧紧，然后再退回 l／10～l／6 圈，
使前轮毂 6 转动灵活，最后将拆下的零件重新装
配拧紧。
Two tapered roller bearings 7 of final drive system
of front axie are pretightened. When checking and
adjusting, remove planet carrier 2 and tighter
adjusting nut 3, then back 1/ 10 - 1 / 6 circle to 图 6-16 最终传动的调整
make front hub 6 rotate flexibly, and finally Fig. 6-16 Final drive system adjustment of front axie
re-assembles and tightens all removed parts. 1.螺栓 2.行星架 3.调节螺母 4.驱动轴
5.太阳轮 6.前轮毂 7.圆锥滚子轴
1.bolts; 2.planet carrier; 3.adjusting nut;
4.driving shaft; 5.sun gear; 6.front hub;
7.taper roller bearing
To Next Page
Loading...