Agrison 80HP CDF - Oil Filter Maintenance and PTO Safety



安全注意事项
Safety precautions
注：以上标识配动力输出 760/1000r/min 的机型!
NOTE: The above represents the machine type equipped with the power-take-off of 760/1000r/min.
1. Under the rated rotation speed of the engine, the
power-take-off shaft rotation speed is 760/1000
r/min.
2. When the power-take-off shaft is the shortest,
the distance between the sleeve and the square
shaft positioning surface shall not be smaller than
10 mm!
3. The meshing length under working conditions of
the transmission shaft shall not be smaller than
150 mm!
4. Upon turning in the field edges, the linkage tools
and machines shall not be lifted too high (the
universal joint can’ t be inclined upwards by more
than 20 ° ), so as to avoid damaging the
power-take-off shaft.
动力输出警告标识
Meaning: Power-take-off warning mark
粘贴位置：动力输出轴防护罩上部
Sticking position: Upper part of the power-take-off shaft shroud
含义：按要求对吸油滤清器进行清洗，并同时检查滤网、
密封圈等易损件，若有损坏，应及时更换。
Meaning: Clean the oil filter as required, and
simultaneously check the filter screen, seal ring, and other
vulnerable parts. If damaged, timely replace them.
粘贴位置：吸油滤清器固定板上。
Sticking position: On the fixing plate of the oil filter.
Maintenance of the oil filter
When the tractor has been
worked for 125 h, the initial
cleaning can be done; after that,
the cleaning will be conducted
once per 500 h; in addition, the
filter screen and seal ring will be
simultaneously checked;
replacement shall be carried out