AgroMax INFINITY 8 User Manual (English)

To Next Page

ASSEMBLY

INSTRUCTIONS

Powerful output combined with expansive and uniform coverage makes the

AgroMax Inﬁnity 8 COB LED Grow Light one of the best LED grow lights available

for both large-scale growing and home use. Unlike standard LED's with ﬁxed

panels, the Inﬁnity 8 COB LED features a modular-bar design, which allows bars to

be adjusted individually in 5 different positions. Each LED grow light bar is housed

inside of a premium aluminum heat sink and ﬁtted with a combination (6) advanced

horticultural COB LED arrays and (24) 3w HP LED chips. Angle customization

capabilities and precision wide-angle optics allow the Inﬁnity COB LED to provide

effective grow lighting from a wider range of height positions.

A | Inﬁnity 8 Driver Housing

C | Light Bar Mounting Bracket

D | Mounting Screw (Light Bar)

F | Wire Hanger

G | Wire Hanging Adapter

E | Mounting Screw (Driver)

B | Inﬁnity 8 30-Diode Light Bar

1 | Using mounting screws (D) attach the

mounting bracket (C) to the light bar (B).

Repeat this for all light bars.

2 | Using mounting screws (E) attach the

mounting bracket (C) to the driver housing (A).

At this point, the light bar’s position can be

adjusted to ﬁt the garden’s needs

4 | Repeat steps 1-3 for all 8 light bars, until the

ﬁxture is completely assembled.

5 | Attach the hanger adapters (G) to the holes

in the driver bar (A) end plate.

4 | Feed the hanging wire (F) through the

stem of the slide lock on the wire hanging

adapter (G)

3 | Connect the daisy-chains from the driver

housing (A) to the light bar (B).

Need help?

Do you have a question about the AgroMax INFINITY 8 and is the answer not in the manual?

AgroMax INFINITY 8 Specifications

General

Brand	AgroMax
Model	INFINITY 8
Category	Lawn and Garden Equipment
Language	English

Summary

Assembly Steps

Attach Mounting Bracket to Light Bar

Attach mounting bracket (C) to light bar (B) using mounting screws (D). Repeat for all light bars.

Mount Bracket to Driver Housing

Attach mounting bracket (C) to driver housing (A) using mounting screws (E). Adjust light bar position as needed.

Connect Daisy-Chain Cables

Connect the daisy-chain cables from the driver housing (A) to the light bar (B).

Complete Fixture Assembly

Repeat assembly steps 1-3 for all 8 light bars until the fixture is completely assembled.

Attach Wire Hanging Adapters

Attach the hanger adapters (G) to the holes in the driver bar (A) end plate.

Feed Hanging Wire

Feed the hanging wire (F) through the stem of the slide lock on the wire hanging adapter (G).

Secure Hanging Height

Hold the free wire while raising the adapter up the wire; the weight will lock the fixture's height.

Lower Fixture Height

Support the fixture's weight, then depress the slide-lock stem to adjust the fixture down the wire.

AgroMax INFINITY 8 User Manual