Why has the crawler tangled up on my AGT Compact Excavator?
If the crawler on your AGT Compact Excavator is tangled, here's what you should check: 1. A loose crawler can cause tangling. Tighten the crawler to resolve this. 2. Moving too fast on rugged terrain can also lead to tangling. Ensure the guide wheel moves slowly in front on rugged roads.
How to fix noisy structural components in AGT Compact Excavator?
Noisy structural components in your AGT Compact Excavator can be caused by: 1. Loose fasteners. Inspect and tighten them. 2. Aggravated abrasion between the bucket and the end face of the bucket rod. Adjust the clearance to less than 1mm.
What to do if bucket teeth keep dropping from my AGT Compact Excavator?
Bucket teeth falling off during operation of your AGT Compact Excavator can occur due to: 1. A deformed spring or weakened elasticity of the bucket tooth pin. Change the bucket tooth pin. 2. An unmatched bucket tooth pin and seat. Replace the bucket tooth pin.
What to do if my AGT Compact Excavator does not move?
If the AGT Compact Excavator doesn't move, several issues could be the cause: * The hydraulic oil level might be low, preventing the main pump from sucking oil. Add enough hydraulic oil to resolve this. * A blocked oil filter could be the culprit. Replace the filter and clean the system. * A damaged engine coupling (like a plastic or elastic plate) will need replacing. * The main pump itself might be damaged, requiring replacement or repair. * Low or zero servo system pressure requires adjustment to regular pressure. If the servo overflow valve fails to increase pressure, disassemble and wash it. If the spring is fatigued, add a washer or change the spring. * A safety valve set at low pressure or stuck needs adjustment to regular pressure. If pressure doesn't increase, disasse...
Details the operational capabilities and versatility of the excavator.
Presents key dimensions and technical specifications of the excavator.
Introduces the main components and overall division of the excavator.
Explains how the engine's power is converted and transmitted to operate the machine.
Describes the fundamental mechanical systems: power, drive, swing, and traveling.
Details the structure of the hydraulic system, specifically the rotary motor.
Details the components and structure of the hydraulic main pump.
Explains the disc valve motors used for the excavator's movement.
Provides schematic diagrams of the main hydraulic control valves.
Covers fundamental principles of the excavator's control system and operations.
Outlines pre-operation checks, maintenance, and preheating procedures.
Guides on basic operations like traveling, steering, and excavation techniques.
Lists crucial safety prohibitions and precautions during operation.
Specifies daily checks for engine oil, hydraulic oil, fuel, and other components.
Provides a schedule for periodic maintenance tasks like greasing and fluid changes.
Details lubrication points for work equipment pins, slewing bearing, and gears.
Covers engine oil level checks, oil filter replacement, and oil type recommendations.
Outlines procedures for checking hydraulic oil level and changing hydraulic oil.
Describes daily and periodic checks for hydraulic hoses and pipelines.
Details fuel tank capacity, filling procedures, and oil-water separator inspection.
Guides on checking battery electrolyte, terminals, and replacing the battery or fuses.
Provides maintenance precautions for various environmental conditions.
Emphasizes the importance of maintenance for performance and service life.
Lists common symptoms and solutions for mechanical system issues.
Addresses problems related to hydraulic system operation and their fixes.
Covers fault codes and diagnostic procedures for the electrical system.
Provides solutions for common engine starting and running problems.
General| Brand | AGT |
|---|---|
| Model | Agrotk-H12 |
| Category | Compact Excavator |
| Language | English |
To Next Page