1 9. Relax or damaged fuel pipes, oil pipes and hydraulic pipes are dangerous. So
you should wear work clothes at work, but do not wear loose or damaged clothes
service, because the hydraulic oil pipe may cause a fire. Do not fold or tap the high
pressure pipe, damaged pipe do not use again. Please do not measure the leak by
hand. Because the very small pinhole can not be seen by the naked eye, and it may be
injured by emitting high- pressure liquid at high speed.Use sheets of paper or splints to
find out the location of the pinhole.
2 0. Each oil pipe joint shall be tightened with the correct torque
wrench.Determine that all heat insulation plates, clamclips and covers are in safe
condition. Avoid overheating, vibration, or friction with other components during
operation.
2 1. If any rotating part is damaged or interfered with any other part, the machine
operation must be stopped.
22. Special attention should be paid to crawler machines during repair or
decomposition.Because plug pins or debris may fly out during loading and
unloading. When the machine sprocket of the machine is removed, the machineIt may
move unexpectedly. So place barriers to prevent the machine from moving and moving
away from the front and rear of the machine.
2 3. Special care should be taken when there are asbestos fibres on the parts. This
dust will cause harm to the body if inhaled. If asbestos fibers are found in
components, the following points must be noted:
a. Do not use compressed air cleaning components
b. Avoid brushing grindstone cotton fiber materials
c. Use wet cleaning or vacuum equipment with a hePA screen when cleaning
d. Use exhaust fan when working for a long time
e. Wear protective mask if there is no other way to control dust
f. Comply with workplace rules
g. Dispose of asbestos fibre waste in accordance with environmental regulations
h. Avoid asbestos-prone areas, especially when filled with air
To Next Page
Loading...