Need help?Do you have a question about the Aguilar AG 500 and is the answer not in the manual?
General| Power Output | 500 Watts |
|---|---|
| Power Amp Section | Class D |
| EQ | 4-Band |
| Effects Loop | Yes |
| Type | Bass Amplifier |
| Preamp Section | Solid State |
| Tone Controls | Bass, Treble |
| Inputs | 1 x 1/4" |
| Outputs | 1 x XLR (balanced out) |
| Speaker Outputs | 2 x 1/4" |
Guidelines for safe operation, including ventilation, fire sources, climate, fluid exposure, and power connection.
Explains that italicized words in the manual refer to physical controls on the AG 500.
Instructions for connecting instrument, footswitch, and speaker cabinets, and setting initial volumes.
Optimizing signal-to-noise ratio using Gain, Clip light, and the -10dB button for input signal adjustment.
Setting volume with the Master control and adjusting the Saturation control for overdrive.
Describes Overcurrent Mode and Thermal/DC Mode, including status indicators and reset procedures.
Details Input Pad, Channel 1, Channel 2, and Effects Loop controls on the front panel.
Covers Send, Return, and Pull -20dB functions for managing external effects.
Covers D.I. Nominal Output Level, Pre/Post Button for signal routing, and Lift/Ground switch for hum elimination.
Describes Speaker Outputs (Speakon, 1/4"), and Tuner Output for signal routing.
Explains the Channel 2 select switch and the Operate/Mute switch, including LED indicators.
Information on registering warranty, 3-year limited warranty, contacting tech support, and requirements for repairs.
To Next Page
